321 Water St. Binghamton, NY 13901 607-723-8600 info@ctandi.org
March 07, 2016
On February 10th the team hooked up a power supply to the X-axis and then the Y-axis motor and with careful application of power showed that the motors are functional after being idle for over 10 (is this correct?) years!.
Next up is to build the prototype controller.
February 23, 2016
From left to right: Lu Yang, Jared Snapp, Alexander Marcus, Wyatt Lendle, Ian Doughty
This is the Spindle Drill Project. It is being done by the SUNY Binghamton Watson Capstone Team (WCP). Supported by the volunteers of CT&I and TC Makerspace. Sponsored by the Binghamton section of the IEEE.
October 07, 2015
Pair of Spindle Drills moved from storage shed to inside TechWorks!
September 16, 2015
Watson Capstone project funded, team begins
August 06, 2015
Jud McCarthy, John Polonsky help set course for VICC
May 23, 2015
Strategic discussion for Spindle Drill use take place
April 23, 2015
Spindle drills arrive at TechWorks! - stored in support shed
March 11, 2015
Spindle drills donated to TechWorks! Bob Lusch and Don Manning remove computers, ancillary equipment prior to shipping to TechWorks!